Start with indoor, non-safety-critical electronics. Adapt the fixture, harness and production recipe to the actual device.
ILLUSTRATIVE APPLICATIONBring together the PCB, enclosure, antenna interfaces and wiring, with the programming and functional checks defined for your device.
Bring together the PCB, enclosure, antenna interfaces and wiring, with the programming and functional checks defined for your device.
Illustrative checks only. Test coverage and acceptance limits are agreed per product.
Discuss this product
A repeatable approach to board mounting, connector interfaces and enclosure integration for indoor, non-safety-critical controllers.
Illustrative checks only. Test coverage and acceptance limits are agreed per product.
Discuss this product
Adapt the carrier, wiring and test recipe around an indoor monitoring instrument without treating every batch as an entirely new factory.
Illustrative checks only. Test coverage and acceptance limits are agreed per product.
Discuss this productAn initial target batch range of 10–500 units, subject to technical and commercial review.
The current concept does not imply readiness for EV traction batteries, medical devices, high-voltage systems or safety-critical controls. Feasibility, facilities and compliance requirements are assessed before a pilot is accepted.
Connect this concept to an agreed electronics pilot production scope. Use the guides to prepare the product, the tests and the unit record.
Before a pilot, agree the product revision, build instructions, firmware, test limits and release criteria. A working prototype is the starting point; the pilot should establish whether another person can build and verify the same product from controlled information.
Read the guideA functional test plan defines what the product must do, how the test will stimulate it, and what evidence establishes a pass. Start with the product requirements and failure modes, then specify the fixture and instruments needed to carry out those checks.
Read the guideA useful production record connects a unit’s identity to the process that built and checked it. Retain the relevant product and recipe revisions, operation results, failed attempts, rework and release decision so the history remains understandable after the batch leaves the bench.
Read the guideBring the working electronics.
Let's define the process around them.